yield strength

[ji:ld streŋθ]
  • 释义

  • 屈变力，屈服强度，抗屈强度;

  • 双语例句
  • 1、

    The V - N microalloy steel with yield strength of 550 MPa is produced by EAF - CSP route.

    目前,在EAF-CSP 流程中通过V -N 微合金化技术可成功生产屈服强度为550MPa的高强度低合金钢.

    互联网
  • 2、

    Desirable properties for forming include low yield strength and high ductility.

    令人满意的成形特性包含了低降伏应力和高延展性.

    互联网
  • 3、

    The yield strength fy of reinforcement is used in design.

    在设计中利用的是钢筋的屈服强度.

    互联网
  • 4、

    Oxgen precipitates ( useful for gettering ) can reduce the yield strength ( critical shear stress ) up to fivefole.

    氧沉淀 ( 可用作吸杂 ) 会使屈服强度 ( 临界剪应力 ) 降低为五分之一.

    辞典例句
  • 5、

    Dislocation strengthening and grain refinement strengthening makes coil 059 with the higher yield strength.

    位错强化与晶粒细化强化是059板卷具有高屈服强度的原因.

    期刊摘选
  • 6、

    FIG. 5 shows the average yield strength as a function of extrusion speed and location.

    图5示出了平均屈服强度与挤压速度和位置的关系.

    互联网
  • 7、

    The results show that the steel has high yield strength and quality forming property.

    结果表明,研制开发出的铌钛微合金化IF钢具有高的屈服强度和优良的成形性能.

    互联网
  • 8、

    The yield strength, tensile ratio and toughness are major quality indexes of steel pipe ( board ).

    屈服强度 、 屈强比、韧性等是钢管 ( 板 ) 的主要质量指标,合理确定这些指标的数值有相当难度.

    互联网
  • 9、

    CuPTiRE anti - erosion hot rolling stripes are divided into two grades in yield strength : 295 MPa, 345 MPa.

    09CuPTiRE耐大气腐蚀热轧钢板按屈服强度分为295MPa级和345MPa级两个级别.

    互联网
  • 10、

    The yield strength ( σ0.2 ) , ultimate tensile strength ( σ b ) and elongation ( δ ) of A 356 - T 6 alloy were 240 MPa, 254.8 MPa and 1.16 % , respectively.

    屈服强度 、 抗拉强度和伸长率分别为240MPa 、 254.8MPa和1.16%.

    互联网
  • 11、

    The creep rate was increased while the yield strength was reduced by anodic dissolution.

    阳极电流不但使恒载荷下的不锈钢蠕变速度增加,而且使屈服强度下降.

    互联网
  • 12、

    Residual stress concentration a notch depends on both notch geometry and yield strength of the material.

    缺口根部的残余应力存在应力集中效应,应力集中值不仅取决于缺口几何形状而且和材料的屈服强度有关.

    互联网
  • 相关短语
  • 相关阅读